Colormatic 2K Hi-Speed primer filler 500ml

SKU: 60 195 33 40
Category: Primer Spray Cans
Manufacturers:

ColorMatic 2K hi-speed primer is universally applicable to all metallic surfaces such as steel, galvanized steel and aluminium. It offers excellent adhesion and corrosion protection and is very fast drying: 1 h (20 ° C). It is perfect for sanding, wet and dry. It is also solvent resistant.

26,81 €

incl. 19% VAT , plus (Standard)

Available immediately
Delivery time: 2 - 3 Workdays (DE - int. shipments may differ)

Description
Question about item

Filler and primer at the same time
Long pot life
Very fast drying time
Very good flow
Universal applicable for polished old paintwork and metal surfaces
Best to use 200 ml can to avoid surplus
Simple, time-saving application
Good adhesion to bare steel, galvanized steel and aluminium
Recoat with ColorMatic pre-fill based paints, acrylic RAL

Physical and Chemical Data

Basis of binder: Acrylic
Colour: grey
Smell: solvent
Efficiency: Depending on consistance and colour of the ground: 400 ml are sufficient for 1,5 m²
Substrate: bare metal cleaned and sanded, zinc-coated metal cleaned and sanded, Aluminium cleaned and sanded, PE-Putty cleaned and sanded, plastic substrates should be pre-treated with ColorMatic 1K Plastic Adhesive
Temperature resistance: to 80°C
Storage stability: 36 month if appropriate storage is provided (=10°-25°C, relative air humidity of max. 60%)
Size: 2 components aerosol cans, maximum nominal volume 500 ml and 200 ml
VOC-value: 114,2g
Pot life: 24 h at least

Environment and Labelling

Environmentally sound: The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.

Using Instructions

Before use, carefully read and observe the warning texts on the label!
Clean surface with ColorMatic silicone remover no. 174469, then sand
Old paintwork has to be cleaned and sanded
2-3 coats, 40 to 50µ
Leave to dry for approximately three minutes between coats
Ready to sand after about 45 min (20 ° C) or 30 min (60 ° C)
Ready to recoat wet-on-wet after 20 minute drying time

Mixing A components with hardener:

Remove the protection cap from the bottom of the can and pull the pin out fully with the help of the inserted ring. This will release the knife, which will penetrate the wall of the aluminium cartridge.
The cartridge will then rotate 360 °, be completely open and release the hardener.
Shake the can vigorously to mix the A components with the hardener in the proper, predetermined ratio.
Shake can vigorously for 2 minutes
Carry out spray test
For professional use only
Wear an appropriate respirator (recommended type A2/P3)