Colormatic Isolation Primer 400ml

SKU: 60 269 36 30
Category: Primer Spray Cans
Manufacturers:

Fast drying isolation primer spray for interior and exterior application on the basis of synthetic resins, with excellent isolation and barrier effect against many different types of stains (especially water stains) on mineral-based substrates (plaster etc.), wood and concrete. Can be painted over with all emulsion paints, alkyd-based, water-based and acrylic paints; not with two-component paints. Adjustable spray cone width (horizontally and vertically).

10,05 CHF

incl. 19% VAT , plus (Standard)

Currently out of stock

Quick and easy to apply
Excellent insulation and protection against many types of stains such as water stains on mineral surfaces (plaster, etc.), timber and concrete
Can be recoated with all paints, alkyd- and water-based acrylic coatings
Based on synthetic resins

Physical and Chemical Data

Basis of binder: Synthetic resins
Colour: white
Smell: solvent
Efficiency: Depending on consistence and colour of the ground:
400 ml are sufficient for approx. 1,0 - 1,5 m²
Substrate: Wood, stone, beton, metal
Drying time (at 20°C, 50% relative air humidity):
Recoat after approx. 30 minutes
The drying time depends on surrounding temperature, air humidity and thickness of the applied coat.
Temperature resistance: to 110°C
Storage stability: 10 years if appropriabte storage provided (=10°-25°C, relative air humidity of max. 60%)
Size: Aerosol cans, maximum nominal volume 400 ml
VOC-value: 254,9 g

Environment and Labelling

Environmentally sound: The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.

Using Instructions

Before use, carefully read and observe the warning texts on the label!
Clean surfaces to be painted thoroughly with ColorMatic silicone cleaner no. 174469, then sand
The area must be dry and free of dust and grease
Shake can well for 3 minutes
Carry out spray test
2-3 coats
For professional use only
Wear an appropriate respirator (type A2/P3)

Content:	0,40 l

Contact data

First name - optional

Last name

Firm - optional

E-Mail

Phone - optional

Fax - optional

Question about item

Your question

Contact data

First name - optional

Last name - optional

E-Mail