Specific additives ensure that ColorMatic 1K Primer for Zinc provides excellent adhesion and corrosion protection, especially for bare zinc-coated steel. This fast-drying product is specially formulated for refinishing OEM-plated zinc-coated car bodies.
Before working with ColorMatic 1K primer for zinc, treat surface with ColorMatic Silicone Remover no. 174469. For best results, we recommend using the ColorMatic 2K hi-speed Primer once the 1K primer for zinc has dried. You can then recoat with mixed paints from our water-baeed or solvent-based mixing systems.
Quality and Properties
- Excellent adhesion and corrosion prevention, especially on bare zinc-coated steel
- Specially formulated for refinishing OEM-plated zinc-coated car bodies
- Simple, time saving application
- Fast drying time
- Recoat with water-based and solvent-based ColorMatic coatings
Physikal and Chemical Data
- Basis of binder: specific mixture of resin
- Colour: light grey
- Smell: solvent
- Efficiency:
- 1 m²
- Substrate:
- bare zinc-coated metal, sanded. Sanded through areas on galvanised substrates
- Temperature resistance: to 90°C
- Storage stability:
- 10 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
- Size:
- Aerosol cans, maximum nominal volume 400 ml
- VOC-value: 259,3g
Environment and Labelling
- Environmentally sound: The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
- Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
- Marking/Labelling: All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Using Instructions
- Before use, carefully read and observe the warning texts on the label!
Applications
- Clean the surface thoroughly and sand
- Damaged area must be dry and free of dust and grease
- Clean undercoat with ColorMatic silicone remover no. 174 469
- Shake the can well for 2 minutes
- Carry out spray test
- Do not use on thermoplastic undercoats!
- For professional use only
- Wear an appropriate respirator (recommended type A2/P3)
Product safety information
Manufacturer information:
European Aerosols GmbH
Kurt-Vogelsang-Str. 6
Baden-Württemberg
Haßmersheim, Deutschland, 74855
info-de@european-aerosols.com
| Item information |
Value |
| Content: |
0,40 l
|
