Quality and properties
- A spray can prepared with propellant gas, solvent, and an additional converter for processing with no added hardener. The 2K acrylic or 2K high-solids topcoat is transferred via a filling device into the can to produce a ready-to-use end product
- The converter converts 2K acrylic topcoat or HS topcoat into a physically-drying coat
- High coverage
- Simple, time-saving application
- Excellent atomisation
- Light blending
- Ideal for spot repairs or refinishing parts
-
Basis of binder: Acrylic resin
-
Colour: depending on filling
-
Smell: solvent
-
Efficiency:
Depending on consistence and colour of the substrate
-
Substrate:
Depending on the colour of the substrate apply Primer Filler HG1 - HG8, ColorMatic 2K Hi-Speed Primer Filler no. 195 327, ColorMatic 1K Primer for ALU no. 190 278, ColorMatic 1K Primer for Zinc no. 190 285, ColorMatic 1K Epoxy Primer no. 174 414, ColorMatic 1K Filler, beige no. 856 556, ColorMatic 1K Filler, grau no. 874 987, cured paint sanded
-
Drying (at 20°C, 50% relative air humidity):
The drying time depends on surrounding temperature, air humidity, thickness of the applied coat and the filled type of paint (refer to information of the paint manufacturer)
-
Storage stability: empty cans: 5 years
Filled cans: depending on type of paint from several hours up to 6 month (information available from your specialis dealer). If appropriate storage provided (=10°-25°C, relative air humidity max. 60%)
-
Size:
Aerosol cans, maximum nominal volume 400 ml, filling quantity 100ml for no. 629013, Universal, filling quantity for Converter 1 to 5 per 75ml
-
VOC-value: 214,7 g
Environmentally sound: The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Before use, carefully read and observe the warning texts on the label!
- Clean the surface to be painted thoroughly with ColorMatic silicone cleaner no. 174469, then sand
- Larger bare surfaces must be pre-primed with the appropriate ColorMatic primer
- The area must be dry and free of dust and grease
- Shake can vigorously for 2 minutes
- Carry out spray test
-
For professional use only
- Wear an appropriate respirator (recommended type A2/P3)
Product safety information
Manufacturer information:
European Aerosols GmbH
Kurt-Vogelsang-Str. 6
Baden-Württemberg
Haßmersheim, Deutschland, 74855
info-de@european-aerosols.com
