Quality and properties
- High-quality acrylic coat
- Simple application
- Professional jet atomization ensures that it can be used on larger surfaces.
- Extremely high pigmentation and specific additives provide high coverage
- High film thickness with good hold
- Light blending
-
Basis of binder: Acrylic
-
Colour: Specific
-
Smell: solvent
-
Degree of gloss: (at measurement angle 60° acc. to DIN 67530)
glossy: 80 gloss units
satin glossy: 30 gloss units
matt: 10 gloss units
-
Efficiency:
Depending on consistence and colour of the ground:
400 ml are sufficient for approx. 0,8 - 1,0 m²
-
Substrate:
ColorMatic 2K Primer Filler no. 195 327
ColorMatic 1K Primer for Aluminium no. 190 278
ColorMatic 1K Primer for Zinc no. 190 285
ColorMatic 1K Epoxy Primer no. 174 414
ColorMatic 1K Filler, beige, no. 856 556
ColorMatic 1K Filler, grey, no. 874 987
'Cured paint, polished
-
Drying time (at 20°C, 50% relative air humidity):
Dust-dry: after approx. 10 minutes
Dry to touch: after approx. 30 minutes
The drying time depends on surrounding temperature, air humidity and thickness of the applied coat.
-
Temperature resistance: to 80°C
-
Storage stability:
10 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
-
Size:
Aerosol cans, maximum nominal volume 400 ml
-
VOC-value: 240,1g
Environmentally sound: The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Before use, carefully read and observe the warning texts on the label!
- Clean the surface to be painted thoroughly with ColorMatic Silicone Remover no. 174469, then sand
- The area must be dry and free of dust and grease
- Shake can vigorously for 2 minutes
- Carry out spray test
- 2-3 coats
- For professional use only
- Wear an appropriate respirator (recommended type A2/P3)
Product safety information
Manufacturer information:
European Aerosols GmbH
Kurt-Vogelsang-Str. 6
Baden-Württemberg
Haßmersheim, Deutschland, 74855
info-de@european-aerosols.com
| Item information |
Value |
| Content: |
0,40 l
|
